Reading Memory (Store & Recall) - Picotest M3510A User Manual

Remote Interface Operation
The following commands show how to use the remote interface operation
to disable or enable the beeper:
SYSTem:BEEPer
SYSTem:BEEPer:STATe {OFF|ON}
4.4.3 Reading Memory (Store & Recall)
M3510A/11A has a memory capacity of 2000 readings. The readings are
stored in first-in-first-out order and the memory type is volatile, which
means the stored readings will be cleared when the multimeter is
power-off. The reading memory feature can be used for all measurement
functions, math operations, trigger operations and reading hold. The
default number of readings to store is 2000 and the anunciator "MEM"
will light up when STORE feature is enabled.
How to use the reading memory
You can store the readings and access to the stored readings through
either the front panel operation or the remote interface operation.
Note: Each datum stored from M3510A/11A to remote interface will
※
be in a first in and first out condition.
Front Panel Operation
Before using the reading memory feature, you need to select a
measurement function (or the math function) first and then select the
trigger mode.
How to enable Reading Memory (to store readings)
Press STORE button, and the multimeter will start to store the readings
produced until the specified number of readings is reached.
How to set the number of readings to be stored
1. Press SHIFT + CONFIG >
RDGS > ENTER buttons.
> ENTER > TRIG SYS >
▷
78 78 78 78
> STORE
▷