Setting Up For Remote Interface - Picotest M3510A User Manual

Contact
Number
1
2
3
4
If you disable the USB interface, the Pass/Fail output function will enable
automatically. Please follow the procedure below to enable/disable this
function.
How to set Interface
Do the procedure SHIFT + CONFIG > INTERFACE > ENTER > USB/GPIB
> ENTER to set the interface.
Warning! You can't use the USB interface if you want to enable the
Pass/Fail signal output. You must use the GPIB interface for remote
control. Please disconnect the USB cable from you multimeter. The signal
from the USB cable may make the Pass/Fail signal output abnormal.

5.2 Setting Up For Remote Interface

You may use the M3510A/11A application developed by PICOTEST to
remotely control the multimeter through either USB or GPIB interface.
How to set up for USB interface
The USB cord should be connected well between M3510A/11A and your
PC. Install the M3510A/11A application in your PC and execute the
program. Click Tool tab for Command Control, then type in your
command. The icons and buttons are shown with red rectangle frames
in Figures 5-2, 5-3 and 5-4.
Note: The icons, pictures and words will be changed or edited with
※
Table 5-1
Signal Name
VBUS
D-
D+
GND
86 86 86 86
Typical Wiring
Assignment
Red
White
Green
Black
Description
Floating
Limit Test Pass
Limit Test Fail
GND