To Connect The Power; To Convert The Voltage - Picotest M3510A User Manual

2.1.2 To connect the power

Check the power-line voltage on the rear panel to see if voltage setting is
correct for your area. There are 4 power lines, 100/120/220/240 on
M3510A/11A for your demand. Change the voltage correctly or replace a
new fuse if the voltage is not correct or the fuse is broken. Please follow
the steps below.

2.1.2.1 To convert the voltage

Warning! Before changing the setting, make sure the multimeter is
disconnected from the AC power. An incorrect voltage setting may cause
severe damage to your instrument.
Warning! The power cord supplied with M3510A/11A contains a
separate ground wire for use with grounded outlets. When proper
connections are made, instrument chassis is connected to power line
ground through the ground wire in the power cord. Failure to use a
grounded outlet may result in personal injury or death due to electric
shock.
Suppose your multimeter is under the AC 220V condition and you want
to convert it to 100V. Follow the following steps to change the voltage
setting.
S tep 1
【 】
Verify that the DMM is disconnected as shown in Figure 2-1.
16 16 16 16