Table of Contents
Advertisement
How to measure resistance
1.
Connect the test leads to the terminals as shown in Figure 3-1 and
3-2.
2.
Set RESOLUTION (Refer to 4.1.3) or skip this step to use the default
setting.
3.
Press Ω2 button for 2-wire measurement or SHIFT+Ω2 buttons for
4-wire measurement.
4.
Select the auto-range function by pressing SHIFT+ESC button on
the front panel or use
desired range.
5.
Connect test leads to your source signal and observe readings
shown on the display. If the input signal is greater than the allowed
range, an overflow message "OVLD" will be displayed.
Figure 3-1
Note: Ensure the chassis ground is leaded to the ground before
※
measurement in order to prevent the measuring deviation.
3.5 Frequency & Period Measurements
M3510A/11A uses an on-board counter to measure the frequency/period.
The measurement band is from 3Hz to 300KHz (or 333 ms to 3.3 µs) and
the measurement voltages range from 100mV to 750V in AC. The range
default setting is auto-range.
Warning! The maximum input allowed is 1000V. Applying excess
voltage may damage your meter.
and
buttons to manually select the
△
▽
32 32 32 32
Figure 3-2
Hide quick links:
Advertisement
Table of Contents
