Upper Row Display
Lower Row Display
2.2.2.1 Annunciators
ADR: Indicates the multimeter is controlled via GPIB Interface.
RMT (REMOTE): Indicates the remote state. (USB Interface)
MAN: Indicates the manual range is taken.
TRIG: Shows the single triggering is enabled.
HOLD: Indicates reading hold function is enabled.
MEM: Indicates the using of internal memory.
MATH: Indicates the "MATH" operation is taken.
FILT: The digital filter is started.
SHIFT: Indicates SHIFT button is pressed.
ERR: Error occurs.
4W: Indicates 4 –wire mode is selected for resistance measurement.
●
)
): Indicates the continuity testing is enabled.
)
OFF: Indicates the front panel display is turned off.
RAT: Indicates the "RATIO" operation is taken.
2nd: Indicates 2ND function in use.
2.2.3 The Rear Panel
The rear panel of the M3510A/11A is shown in Figure 2-20. This figure
includes important abbreviated information that should be reviewed
before using the instrument.
Figure 2-17
27 27 27 27