Switching Between The Service Processor And The System Console - Sun Oracle Netra T5440 Administration Manual

Note – To cause the parameter changes to take effect, you can also power cycle the
system using the front panel Power button.
You can now issue system commands and view system messages using your local
graphics monitor. Continue with your installation or diagnostic procedure, as
needed.
If you want to redirect the system console back to the serial management and
network management ports, see
Variable Settings" on page
Switching Between the Service Processor
and the System Console
The service processor features two management ports, labeled SER MGT and NET
MGT, located on the server's back panel. If the system console is directed to use the
serial management and network management ports (the default configuration), these
ports provide access to both the system console and the ILOM command-line
interface (the ILOM service processor prompt), each on a separate channel (see
FIGURE 1-5
18 Sun Netra T5440 Server Administration Guide • April 2010
26.
).
"System Console OpenBoot Configuration