Table of Contents
Advertisement
Note – When you access the ILOM service processor for the first time, the default
username is root and the default password is changeme.
For more information on navigating to or from the ILOM prompt, see the following:
"To Obtain the ok Prompt" on page 25
■
"Switching Between the Service Processor and the System Console" on page 18
■
Access Through Multiple Controller Sessions
Up to five ILOM sessions can be active concurrently, one session through the serial
management port and up to four SSH sessions through the network management
port. Users of each of these sessions can issue commands at the -> prompt.
However, only one user at a time can access the system console, and then only if the
system console is configured to be accessible through the serial and network
management ports. For more information, see:
"Accessing the Service Processor" on page 7
■
"Activating the Network Management Port" on page 8
■
Any additional ILOM sessions afford passive views of system console activity, until
the active user of the system console logs out.
Reaching the -> Prompt
There are several ways to obtain the -> prompt:
If the system console is directed to the serial management and network
■
management ports, you can type the ILOM escape sequence (#.).
You can log in directly to the service processor from a device connected to the
■
serial management port. See
You can log in directly to the service processor using a connection through the
■
network management port. See
page
8.
"Accessing the Service Processor" on page
"Activating the Network Management Port" on
Chapter 1
Configuring the System Console
7.
21
Advertisement
Table of Contents
