Table of Contents
Advertisement
"To Connect the Ethernet Network Cables" on page 69
■
"To Connect Power Cables to the Server" on page 70
■
The server also has serial and USB ports available for connections to optional
devices (see
"Cable Connections and Ports" on page
Note – When you are finished connecting the cables to the server, ensure that the
server can slide smoothly in and out of the rack without binding or damaging the
cables..
▼ To Connect the Service Processor Serial
Management Port
The service processor serial management port is marked SER MGT (
the leftmost RJ-45 port on the rear panel.
Note – The cable and DB-9 RJ-45 adapters are for the host serial port, and not for
the server SER MGT port.
Use this port for server management. This port is needed to set up the service
processor network management port, as detailed in
Network Management Port" on page
Note – Use the service processor serial management port only for server
management. It is the default connection between the service processor and a
terminal or a computer.
Caution – Do not attach a modem to this port.
●
Connect a Category 5 cable from the SER MGT serial management port to the
terminal device.
When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.
62).
"Enabling the Service Processor
82.
Chapter 4
). It is
FIGURE 4-3
Cabling the Server
67
Advertisement
Table of Contents
