▼ To Reconfigure a Device Manually
●
At the -> prompt, type:
-> set Device-Identifier component-state=enabled
where the Device-Identifier is any device identifier from the table in the procedure
"To Unconfigure a Device Manually" on page
Note – The device identifiers are not case sensitive. You can type them as uppercase
or lowercase characters.
You can use the ILOM set Device-Identifier component_state=enabled
command to reconfigure any device that you previously unconfigured with the
set Device-Identifier component_state=disabled command.
Displaying System Fault Information
ILOM software enables you to display current valid system faults.
46.
Chapter 2
Managing RAS Features and System Firmware
47