Automatic System Recovery User Commands; Enabling And Disabling Automatic System Recovery - Sun Oracle Netra T5440 Administration Manual

If keyswitch_state is set to diag, the system can power itself on using preset
values of diagnostic properties (/HOST/diag level=max, /HOST/diag mode=
max, /HOST/diag verbosity=max) to provide thorough fault coverage. This
option overrides the values of diagnostic properties that you might have set
elsewhere.
ILOM Property Settings for Reset Scenario
TABLE 2-6
Property Value
normal or service
mode
min or max
level
trigger power-on-reset error-reset
The default settings for these properties are:
mode = normal
■
level = min
■
trigger = power-on-reset error-reset
■
For instructions on automatic system recovery (ASR), see
Automatic System Recovery" on page

Automatic System Recovery User Commands

The ILOM commands are available for obtaining ASR status information and for
manually unconfiguring or reconfiguring system devices. For more information, see:
"Unconfiguring and Reconfiguring Devices" on page 45
■
"To Reconfigure a Device Manually" on page 47
■
"Obtaining Automatic System Recovery Information" on page 45
■
Enabling and Disabling Automatic System
Recovery
The automatic system recovery (ASR) feature is not activated until you enable it.
Enabling ASR requires changing configuration variables in ILOM as well as in
OpenBoot firmware.
43.
Chapter 2 Managing RAS Features and System Firmware
"Enabling and Disabling
43