Accessing The System Console Through A Graphics Monitor; Accessing The Service Processor; Using The Serial Management Port; To Use The Serial Management Port - Sun Oracle Netra T5440 Administration Manual

Accessing the System Console Through a Graphics
Monitor
The Sun Netra T5440 server is shipped without a mouse, keyboard, monitor, or
frame buffer for the display of bitmapped graphics. To install a graphics monitor on
the server, you must install a graphics accelerator card into a PCI slot, and attach a
monitor, mouse, and keyboard to the appropriate front or rear USB ports.
After starting the system, you might need to install the correct software driver for
the PCI card you have installed. For detailed hardware instructions, see
the System Console Through a Local Graphics Monitor" on page
Note – POST diagnostics cannot display status and error messages to a local
graphics monitor.

Accessing the Service Processor

The following sections describe methods of accessing the service processor.

Using the Serial Management Port

This procedure assumes that the system console uses the serial management and
network management ports (the default configuration).
When you are accessing the system console using a device connected to the serial
management port, you first access the ILOM service processor and its -> prompt.
After connecting to the ILOM service processor, you can switch to the system
console.
For more information about the ILOM serv ice processor, refer to the ILOM user's
guide and the Integrated Lights Out Management 2.0 Supplement for the Sun Netra
T5440 Server.

▼ To Use the Serial Management Port

1. Ensure that the serial port on your connecting device is set to the following
parameters:
9600 baud
■
Chapter 1 Configuring the System Console
"Accessing
16.
7