Sun Oracle Netra T5440 Administration Manual page 83

4. Verify that the device has been removed from the device tree.
Type the following command:
# cfgadm -al
Ap_Id
c0
c0::dsk/c0t0d0
c0::dsk/c0t1d0
c0::dsk/c0t2d0
c0::dsk/c0t3d0
c1
c1::dsk/c1t0d0
usb0/1
usb0/2
usb1/1.1
usb1/1.2
usb1/1.3
usb1/1.4
usb1/2
#
Note that c0t3d0 is now unavailable and unconfigured. The corresponding
hard drive OK-to-Remove LED is lit.
5. Remove the hard drive, as described in Sun Netra T5440 Server Service Manual.
The blue OK-to-Remove LED goes out when you remove the hard drive.
6. Install a new hard drive, as described in Sun Netra T5440 Server Service Manual.
7. Configure the new hard drive.
Type the following command:
# cfgadm -c configure Ap-Id
For example:
# cfgadm -c configure c1::dsk/c0t3d0
The green Activity LED flashes as the new disk at c1t3d0 is added to the device
tree.
8. Verify that the new hard drive is in the device tree.
Type the following command:
# cfgadm -al
Ap_Id
c0
Type Receptacle
scsi-bus connected
disk connected
disk connected
disk connected
unavailable connected
scsi-bus connected
CD-ROM connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
Type Receptacle
scsi-bus connected
Occupant
configured
configured
configured
configured
configured
unconfigured
configured
unconfigured
unconfigured
unconfigured
unconfigured
unconfigured
unconfigured
unconfigured
Occupant
configured
Chapter 3 Managing Disk Volumes
Condition
unknown
unknown
unknown
unknown
unknown
unknown
unknown
ok
ok
ok
ok
ok
ok
ok
Condition
unknown
69