Sun Oracle Netra T5440 Administration Manual page 102

OpenBoot Configuration Variables Stored on the System Configuration Card (Continued)
TABLE C-1
Variable
diag-switch?
local-mac-address?
fcode-debug?
scsi-initiator-id
oem-logo
oem-logo?
oem-banner
oem-banner?
ansi-terminal?
screen-#columns
screen-#rows
ttya-mode
output-device
input-device
auto-boot-on-error?
load-base
auto-boot?
88 Sun Netra T5440 Server Administration Guide • April 2010
Possible Values Default Value
true, false false
true, false true
true, false false
0-15 7
No default
true, false false
No default
true, false false
true, false true
0-n 80
0-n 34
9600,8,n,1,- 9600,8,n,1,-
virtual-conso virtual-conso
le, screen
le
virtual-conso virtual-conso
le, keyboard
le
true, false false
0-n 16384
true, false true
Description
If true:
• OpenBoot verbosity is set to maximum
If false:
• OpenBoot verbosity is set to minimum
If true, network drivers use their own
MAC address, not the server MAC address.
If true, include name fields for plug-in
device FCodes.
SCSI ID of the Serial Attached SCSI
controller.
If true, use custom OEM logo; otherwise,
use the server manufacturer's logo.
If true, use custom OEM banner.
If true, enable ANSI terminal emulation.
Sets number of columns on screen.
Sets number of rows on screen.
Serial management port (baud rate, bits,
parity, stop, handshake). The serial
management port only works at the default
values.
Power-on output device.
Power-on input device.
If true, boot automatically after system
error.
Address.
If true, boot automatically after power on
or reset.