To Enable Automatic System Recovery; To Disable Automatic System Recovery - Sun Oracle Netra T5440 Administration Manual

▼ To Enable Automatic System Recovery

1. At the -> prompt, type:
-> set /HOST/diag mode=normal
-> set /HOST/diag level=max
-> set /HOST/diag trigger=power-on-reset
2. At the ok prompt, type:
ok setenv auto-boot true
ok setenv auto-boot-on-error? true
Note – For more information about OpenBoot configuration variables, refer to the
service manual for your server.
3. To cause the parameter changes to take effect, type:
ok reset-all
The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its default
value).
Note – To store parameter changes, you can also power cycle the system using the
front panel Power button.

▼ To Disable Automatic System Recovery

1. At the ok prompt, type:
ok setenv auto-boot-on-error? false
2. To cause the parameter changes to take effect, type:
ok reset-all
The system permanently stores the parameter change.
44 Sun Netra T5440 Server Administration Guide • April 2010