Accessing The System Console Through A Tip Connection; Tip Connection - Sun Oracle Netra T5440 Administration Manual

Serial Port (RJ-45 Connector) Pin
Pin 1 (RTS)
Pin 2 (DTR)
Pin 3 (TXD)
Pin 4 (Signal Ground)
Pin 5 (Signal Ground)
Pin 6 (RXD)
Pin 7 (DSR /DCD)
Pin 8 (CTS)
The following table shows the crossovers that the cable must perform for
connecting to a typical terminal server..
2. Open a terminal session on the connecting device, and type:
% ssh IP-address-of-terminal-server port-number
For example, for a Sun Netra T5440 server connected to port 10000 on a terminal
server whose IP address is 192.20.30.10, you would type:
% ssh 192.20.30.10 10000
Accessing the System Console Through a Tip
Connection
Use this procedure to access the Sun Netra T5440 server system console by
connecting the serial management port (SER MGT) to the serial port of another
system (
12 Sun Netra T5440 Server Administration Guide • April 2010
If the pinouts for the serial management port do not correspond with the
pinouts for the RJ-45 ports on the terminal server, you need to make a
crossover cable that connects each pin on the Sun Netra T5440 server serial
management port to the corresponding pin in the terminal server's serial port.
).
FIGURE 1-4
Terminal Server Serial Port Pin
Pin 1 (CTS)
Pin 2 (DSR)
Pin 3 (RXD)
Pin 4 (Signal Ground)
Pin 5 (Signal Ground)
Pin 6 (TXD)
Pin 7 (DTR)
Pin 8 (RTS)