Accessing The System Console Through A Terminal Server; To Access The System Console Through A Terminal Server; Accessing The System Console Through A - Sun Oracle Netra T5440 Administration Manual

Note – If you have configured your server to use static IP addresses, but you wish
to reset your network to use Dynamic Host Configuration Protocol (DHCP), type the
following commands:
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
->
4. Type the following command to verify network settings:
-> show /SP/network
To connect through the network management port, use ssh to the IP address you
specified in

Accessing the System Console Through a

Terminal Server
The following procedure assumes that you are accessing the system console by
connecting a terminal server to the serial management port (SER MGT) of your
server.
▼ To Access the System Console Through a Terminal
Server
1. Complete the physical connection from the serial management port to your
terminal server.
The serial management port on the Sun Netra T5440 server is a data terminal
equipment (DTE) port. The pinouts for the serial management port correspond
with the pinouts for the RJ-45 ports on the serial interface breakout cable supplied
by Cisco for use with the Cisco AS2511-RJ terminal server. If you use a terminal
server made by another manufacturer, check that the serial port pinouts of the
Sun Netra T5440 server matches those of the terminal server you plan to use.
If the pinouts for the server serial ports correspond with the pinouts for the RJ-45
ports on the terminal server, you have two connection options:
10 Sun Netra T5440 Server Administration Guide • April 2010
Step 3.