Installation; Site Requirements; Fabric Management Workstation; Switch Power Requirements - Qlogic SANbox2-16 Installation Manual

This section describes how to install and configure the SANbox2-16 switch. It also
describes how to load new firmware and how to recover a disabled switch.
4.1

Site Requirements

Consider the following items when installing a SANbox2-16 switch:
4.1.1

Fabric Management Workstation

The requirements for fabric management workstations running SANbox Manager
are described in
Operating System
Memory
Disk Space
Processor
Hardware
Internet Browser
Telnet workstations require an RJ-45 Ethernet port or an RS-232 serial port and
an operating system with a Telnet client.
4.1.2

Switch Power Requirements

Operating voltage requirements are as follows:
59021-07 A

Installation

Fabric management workstation
Power requirements
Environmental conditions
Table 4-1:
Table 4-1. Management Workstation Requirements
Windows® NT, 2000, 95/98
Linux® 7.2 Red Hat®
Solaris™
128 MB or more
150 MB per installation
300 MHz or faster
CD-ROM drive, RS-232 serial port,
Microsoft® Internet Explorer® or Netscape Navigator®
90 to 137 VAC; 47 to 63 Hz
180 to 265 VAC; 47 to 63 Hz
Section 4
RJ-45
Ethernet port
4-1