Reset Command - Qlogic SANbox2-16 Installation Manual

D

Reset Command

Resets the switch configuration parameters. If you omit the keyword, the default is
Reset Switch.
Authority
Admin session
Syntax
reset
config [config_name]
factory
port [port_number]
security
snmp
switch (default)
system
zoning
Keywords
config [config_name]
Resets the configuration given by [config_name] to the factory default values for
switch, port, alarm threshold, and zoning configuration. If [config_name] does not
exist on the switch, a configuration with that name will be created. If you omit
[config_name], the active configuration is reset. You must activate the
configuration for the changes to take effect. Refer to
for switch, port, and alarm threshold configuration default values.
factory
Resets switch configuration, port configuration, alarm threshold configuration,
zoning configuration, SNMP configuration, system configuration, security
configuration, and zoning to the factory default values. The switch configuration is
activated automatically. Refer to
port [port_number]
Reinitializes the port given by [port_number]. Ports are numbered beginning
with 0.
security
Clears the security database and deactivates the active security set. The security
configuration value, autosave, and fabric binding remain unchanged. Refer to
Table B-11
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table B-9
switch
Resets the switch without a power-on self test. This reset disrupts traffic and
activates the pending firmware. This command also closes all management
sessions. This is the default. To reset the switch with a power-on self test, refer to
the "Hardreset Command" on page
traffic, refer to the
59021-07 A
for security configuration default values.
for SNMP configuration default values.
"Hotreset Command" on page
Table B-5
Table B-5 through Table
B-16. To reset the switch without disrupting
B-20.
B – Command Line Interface
Reset Command
through Table B-8
B-10.
B-27