B-16 Set Config Zoning Parameters - Qlogic SANbox2-16 Installation Manual

D
zoning
Initiates an editing session in which to change switch zoning attributes. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
FC-SW-2 AutoSave
Default Visibility
Examples
The following is an example of the Set Config Port command:
SANbox2 #> admin start
SANbox2 (admin) #> config edit
SANbox2 (admin-config) #> set config port 1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring Port Number:
------------------------
AdminState
LinkSpeed
PortType
SymPortName
ALFairness
DeviceScanEnable (True / False)
ForceOfflineRSCN (True / False)
ARB_FF
59021-07 A
Table B-16. Set Config Zoning Parameters
Parameter
1
(1=Online, 2=Offline, 3=Diagnostics, 4=Down)
(1=1Gb/s, 2=2Gb/s, 3=Auto)
(GL / G / F / FL / Donor)
(string, max=32 chars)
(True / False)
(True / False)
B – Command Line Interface
Set Config Command
Description
Available only when the FC-SW-2
Compliant parameter is True, this
parameter enables (True) or disables
(False) the saving of changes to active
zone set in the switch's permanent
memory. Refer to "FC-SW-2 Compliant"
on page B-43. The default is True.
Enables (All) or disables (None)
communication among the switch's
ports/devices and the fabric in the
absence of an active zone set. The
default is All.
[Online]
[Auto ]
[GL ]
[Port1 ]
[False ]
[True ]
[False ]
[False ]
B-45