Qlogic SANbox2-16 Installation Manual page 77

D
2. Place the switch in maintenance mode. Press and hold the Maintenance
button, then power up the switch. Refer to
page 5-12
mode.
3. Establish a Telnet session with the switch using the default IP address
10.0.0.1.
4. Enter the account name (prom) and password (prom), and press the Enter
key.
5. The following menu is displayed. Enter "6" (Remake Filesystem) and press
the Enter key to recreate the configuration file.
6. When the recreate process is complete, select option 7 to reset the switch
and exit maintenance mode.
7. If a previously saved configuration file is available for the switch, do the
following to restore the configuration file.
a.
59021-07 A
for more information about placing the switch in maintenance
telnet 10.0.0.1
Sanbox2 login: prom
Password:xxxx
[username@host:Itasca]% telnet 10.0.0.1
Trying 10.0.0.1...
Connected to 10.0.0.1.
Escape character is '^]'.
0) Exit
1) Image Unpack
2) Reset Network Config
3) Reset Password File
4) Copy Log Files
5) Remove Switch Config
6) Remake Filesystem
7) Reset Switch
8) Show Firmware Versions
9) Set Active Image
Option: 6
Establish communications with the switch using the File Transfer
Protocol (FTP). Enter one of the following on the command line:
>ftp xxx.xxx.xxx.xxx
or
>ftp switchname
where xxx.xxx.xxx.xxx is the switch IP address and switchname is the
switch name associated with the IP address.
5 – Diagnostics/Troubleshooting
POST Diagnostics
"Recovering a Switch" on
5-3