Qlogic SANbox2-16 Installation Manual page 202

B – Command Line Interface
Zoning Command
limits
Displays the number of zone sets, zones, aliases, members per zone, members
per alias, and total members in the zoning database. This keyword also displays
the zoning database limits.
list
Lists all fabric zoning definitions. This keyword is does not require an Admin
session nor a Zoning Edit session.
restore
Reverts the changes to the zoning database that have been made during the
current Zoning Edit session since the last Zoning Save command was entered.
save
Saves changes made during the current Zoning Edit session. The system will
inform you that the zone set must be activated to implement any changes. This
does not apply if you entered the Zoning Clear command during the Zoning Edit
session.
Examples
The following is an example of the Zoning Edit command:
SANbox2 #> admin start
SANbox2
SANbox2
.
.
SANbox2
Zoning edit mode will be canceled.
SANbox2
B-98
(admin) #> zoning edit
(admin-zoning) #>
(admin-zoning) #> zoning cancel
(admin) #> admin end
Please confirm (y/n): [n]
D
y
59021-07 A