Qlogic SANbox2-16 Installation Manual page 118

B – Command Line Interface
Group Command
members [group]
Displays all members of the group given by [group]. This keyword is available
without an Admin session.
remove [group] [members]
Remove the port/device worldwide name given by [member] from the group given
by [group].
rename [group_old] [group_new]
Renames the group given by [group_old] to the group given by [group_new].
Notes
Refer to the
managing groups in security sets.
Examples
The following is an example of the Group Add command:
SANbox2 (admin-security) #> group add Group_1
Group Type is ISL
Group Member (wwn)
Authentication (None/Chap)
Secret (16 byte hex value)
The following is an example of the Group Edit command:
SANbox2 (admin-security) #> group edit G1 10:00:00:c0:dd:00:90:a3
A list of attributes with formatting and default values will follow
Enter a new value or simply press the ENTER key to accept the current value
with exception of the Group Member WWN field which is mandatory.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Type : ISL
Group Member: 10:00:00:c0:dd:00:90:a3
Authentication (None / Chap)
Secret
Finished configuring attributes.
To discard this configuration use the security cancel command.
The following is an example of the Group List command:
SANbox2 #> group list
Group
-----
group1 (ISL)
group2 (Port)
B-14
"Securityset Command" on page B-35
(32-character hex value
SecuritySet
-----------
alpha
alpha
for information about
[00:00:00:00:00:00:00:00 ] 10:00:00:c0:dd:00:90:a4
[None ] Chap
[0 ] 12345678123456781234567812345678
[None]
[ ]
D
59021-07 A