Qlogic SANbox2-16 Installation Manual page 150

B – Command Line Interface
Set Config Command
InteropCredit (decimal value, 0-255)
ExtCredit
FANEnable
LCFEnable
MFSEnable
MSEnable
NoClose
IOStreamGuard (Enable / Disable)
VIEnable
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
The following is an example of the Set Config Security command:
SANbox2 (admin-config) #> set config security
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
AutoSave
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
B-46
(dec value, increments of 11, non-loop only)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False) [True]
D
[0 ]
[0 ]
[True ]
[False ]
[False ]
[True ]
[False ]
[Disable]
[False ]
59021-07 A