Security Command - Qlogic SANbox2-16 Installation Manual

B – Command Line Interface

Security Command

Security Command
Opens a Security Edit session in which to manage the security database on a
switch. Refer to the
Command" on page
Authority
Admin session. The keywords Active, History, Limits, and List are available
without an Admin session.
Syntax
security
active
cancel
clear
edit
history
limits
list
restore
save
Keywords
active
Displays the active security set, its groups, and group members. This keyword
does not require an Admin session.
cancel
Closes a Security Edit session without saving changes. Use the Edit keyword to
open a Security Edit session.
clear
Clears all inactive security sets from the volatile edit copy of the security
database. This keyword does not affect the non-volatile security database.
However, if you enter the Security Clear command followed by the Security Save
command, the non-volatile security database will be cleared from the switch.
Note:
edit
Initiates a Security Edit session in which to make changes to the security
database. A Security Edit session enables you to use the Group and Securityset
commands to create, add, and delete security sets, groups, and group members.
To close a Security Edit session and save changes, enter the Security Save
command. To close a Security Edit session without saving changes, enter the
Security Cancel command.
B-32
"Group Command" on page B-12
B-35.
The preferred method for clearing the security database from the
switch is the Reset Security command. Refer to the
on page B-27.
D
and the "Securityset
"Reset Command"
59021-07 A