B-4 Group Member Attributes - Qlogic SANbox2-16 Installation Manual

D
copy [group_source] [group_destination]
Creates a new group named [group_destination] and copies the membership into
it from the group given by [group_source].
create [group] [type]
Creates a group with the name given by [group] with the type given by [type]. A
group name must begin with a letter and be no longer than 64 characters. Valid
characters are 0-9, A-Z, a-z, _, $, ^, and -. The security database supports a
maximum of 16 groups. If you omit [type], ISL is used. [type] can be one of the
following:
ISL
Configures security for attachments to other switches.
Port
Configures security for attachments to N_Port devices.
MS
Configures security for attachments to N_Port devices that are issuing
management server commands.
edit [group] [member]
Initiates an editing session in which to change the attributes of a worldwide name
given by [member] in a group given by [group]. Member attributes that can be
changed are described in
Attribute
DomainBinding
Authentication
Secret
list
Displays a list of all groups and the security sets of which they are members. This
keyword is available without an Admin session.
59021-07 A
Table B-4:
Table B-4. Group Member Attributes
Binds the ISL group member worldwide name to the specified
switch domain ID. This option is available only if
FabricBindingEnabled is set to True using the Set Config
Security command. Refer to the
page B-39. 0 (zero) specifies no binding.
Type of authentication to use:
None – no authentication
CHAP – Challenge Handshake Authentication Protocol
(ISL and Port groups only)
MD5 – MD5 hash function (MS groups only)
SHA-1 – SHA-1 hash function (MS groups only)
16-byte (ISL and Port groups) or 20-byte (MS groups) hex
string used for authentication purposes. Applies only for CHAP,
MD5, and SHA-1 authentication.
B – Command Line Interface
Group Command
Description
"Set Config Command" on
B-13