Table of Contents
Advertisement
Remote
Communication and
Control
This section discusses SIS programming and control of the MPS 602 including:
•
•
•
•
Connection Options
The MPS 602 can be remotely connected via a host computer or other device (such as a
control system) attached to the rear panel RS-232 port or the front panel USB Config port.
The switcher can be set up and controlled using SIS commands. SIS commands are
executed using the Extron DataViewer program, found at on the Extron Website.
RS-232 protocol:
•
•
For additional details on connecting the RS-232 port, see the "Remote Control Port" section
below.
USB port details:
The Extron USB driver must be installed before use (see
on page 45).
Remote Control Port (RS-232)
The RS-232 port connector (see
device such as a computer running a HyperTerminal utility or the Extron DataViewer utility,
which can generate the proper command codes and recognize switcher responses. The
port makes serial control possible. Use the protocol information listed above to make the
connection.
Connection Options
Host-to-MPS Communications
Using the Command and Response Table
Command and Response Table for SIS Commands
9600 baud
•
No parity
8 data bits
•
No flow control
•
1 stop bit
Front Panel Configuration Port
Control
Ports,
on page 9) connects to a host
R
MPS 602 • Remote Communication and Control
44
Advertisement
Table of Contents
