Cabling The Mps 602 Switcher - Extron electronics MPS 602 User Manual

Cabling the MPS 602 Switcher
The MPS switcher can be connected to as many as six input devices. It can output to one
of two outputs (HDMI or DTP). Follow the steps below and the installation example (see
MPS 602 Application Diagram
1.
2.
3.
4.
5.
6.
7.
8.
9.
Turn off power to the MPS switcher and all devices that are connected to it.
If the MPS switcher is rack, table, wall, or through-desk mounted, position the brackets
and install the mounting screws (see
Attach up to two analog, three HDMI (or DVI-D with appropriate adapters) sources,
and one DTP transmitter device to the switcher (see
page 5).
Connect the switcher HDMI output to a compatible display device, or the DTP output to
a compatible DTP receiver (see
For stereo audio input, connect up to six audio sources to the corresponding audio
inputs of the analog (inputs 1 and 2), HDMI (inputs 3, 4, and 5), or DTP (input 6) video
groups (see Rear Panel Connections).
For vocal input, connect a mic to the Mic Line input (see
Set the phantom power switch if necessary.
For output, connect an appropriate audio output device depending on the switcher
model:
All models – Connect an audio amplifier to the program or fixed Audio Output
•
Rear Panel
connectors (see
MPS 602SA – Connect stereo speakers to the speaker output connections.
•
MPS 602MA – Connect a 70V line speaker system to the speaker output
•
connections.
NOTE: The program and fixed outputs are on all models. On models with
internal amplifiers the outputs are used exactly as they are on non-amplified
models.
Connect a control PC or controller to the switcher using:
The rear panel RS-232 port and a 3-pole captive screw connector (see
•
Control Port (RS-232)
The front panel USB configuration port (see
•
page 45).
Power up the input and output devices, then connect power to the rear AC connector
of the switcher (see Rear Panel Connections
on page 4).
Mounting the Switcher
Rear Panel Connections
Rear Panel Connections).
Connections).
on page 44).
Front Panel Configuration Port
on page 5).
on page 55).
on
Rear Panel Connections).
Remote
on
MPS 602 • Installation 12