Using The Command And Response Table; Symbol Definitions - Extron electronics MPS 602 User Manual

Using the Command and Response Table

The command and response tables are on the following pages. Symbols used in the
tables represent variables in the command and response fields. Command and response
examples are shown throughout the tables. Unless otherwise stated, SIS commands are not
case sensitive. The ASCII to HEX conversion table below is for use with the command and
response tables.
Space
Figure 49.

Symbol definitions

W or
ASCII to Hex Conversion Table
ASCII to Hex Conversion Table
=
] CR/LF (carriage return/line feed)
=
Carriage return (no line feed, hex 0D)
| or }
=
Space character in command or response (all other spaces shown are for clarity)
•
E
=
Escape
X! =
HDMI/DTP audio output select
0 = Embedded audio
1 = Analog audio
Video output select
X@ =
1 = RGB
2 = HDMI/DTP
X# =
Status, 0 = off, disabled, muted, 1 = on, enabled, unmuted
= Mic gain in 1 dB steps, 0 to 60
X$
= Mic attenuation in 1 dB steps, 1 to 18
X%
= Mic level in 1 dB steps, – 18 to +60,
X^
X* = Mic talk-over threshold level in dB
0 to 30, default = 8
=
X1) Program volume adjustment range, 0 to 100
X1! =
Input select 0 through 6 (0 = deselect) for digital output; 1 or 2 only for local analog output.
X1@ =
Program audio ducking level in talk-over mode in dB (0 to 30,0 = off)
X1# =
Audio input gain or attenuation in dB (-18 to +24, in 1 dB steps)
X1$ =
Audio input gain in dB (0 to 24, in 1 dB steps)
X1%
=
Audio input attenuation in dB (1 to 18, in 1 dB steps)
X1^ = EDID slot number from lookup table (see
1-56 = factory EDIDs
57 = VGA automatic mode slot
58 = HDMI/DTP automatic mode slot
59-64 = user loaded EDID slots
X1&
=
Raw EDID HEX value: 128 or 256 Byte (text form)
X1* =
EDID native resolution and refresh rate
•
User Assigned EDID Mode
MPS 602 • Remote Communication and Control
on page 20):
47