ASCOM d62 User Manual page 88

User Manual
Ascom d62 DECT Handset
Not allowed
LED Error Indications
See also chapter
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third handset, that is another handset than the "old" (the replaced handset) and
"new" (the replacement handset) handset, is inserted into the charger during Easy
Replacement, this error indication appears. Change to the correct handset.
2) The charger has found that Easy Replacement does not work. Change back to the "new"
handset.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both telephones need to be sent for service.
8 April 2016 / Ver. M
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
1) The user cannot login to the
handset with the shared phone
functionality enabled, due to
another handset currently using
the same extension (User).
2) The user cannot logout from
the handset with the shared
phone functionality enabled, due
to incorrect password (AC code).
3) The extension (User) does not
exists.
4) The password is not correct.
LED Indications during Easy Replacement
TD 92477EN
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in the
base station(s); and/or,
Note: If Ascom's base station(s)
is used, the software version
must be 3.1.x or greater.
3) Use supported base
station(s). Ask your supplier.
1) Logout from the handset
that uses the same extension.
2) Enter #11*<AC code># on
the keypad and press the off-
hook key to logout from the
shared phone.
3) Make sure that you entered
correct extension. If needed,
contact the system
administrator.
4) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.
on page 86.
81