Write And Send A Message; Open A Sent Message - ASCOM d62 User Manual

User Manual
Ascom d62 DECT Handset
The Templates Menu
To access a template and use it in one of the ways described above, perform the following
steps:
1 Open the "Templates" menu as described in the context in which the template is
being used.
2 Select the required message from the "Templates" menu.
3 To edit the message, use the handset navigation key to move to different parts of
the message, the handset key pad to add additional text, and the "Clear" soft key to
delete unwanted text
6.3.9

Write and Send a Message

A message can be constructed from scratch, or from a predefined template that can be used
as it is or edited. The maximum message length is normally 160 characters but may be less
depending on the character set used.
The first character entered is always upper-case, followed by lower-case character. However,
this may be overriden by pressing the * -key before entering the character.
When pressing a key, the first available character for that key is displayed, see
Alphanumeric Keys
the key until that character appears in the display.
The keys 0-9, * or # can be used. Keys 0 and 1 contains special characters, see
Alphanumeric Keys
For example, to enter the character E, press key 3 twice. "E" appears in the display and is
selected after a timeout or when another key is pressed.
TIP: If the system supports UTF-8 character encoding, the input language can be changed
temporarily by long pressing
foreign language.
To delete a character, press "Clear".
To construct and send a message, perform the following steps:
1 Enter "Messaging" menu, see
2 Select "Write new message".
3 Write the message from scratch or select a message template by pressing the "More"
soft key and, if required, edit the message as described in
page 37.
NOTE: The "More" key is not displayed if no message templates have been defined.
4 When the message is complete, press "Send".
5 Enter the call number.
6 Press "Send" to send the message.

6.3.10 Open a Sent Message

1 Enter "Messaging" menu, see
2 Select "Sent".
3 Select message.
4 Press "View" to read the message.
8 April 2016 / Ver. M
on page 13. To enter the other characters supported by the key, press
on page 13 to see all characters.
. This can be used to temporarily access characters in a
3.4 Messaging
3.4 Messaging
on page 17.
The Templates Menu
on page 17.
TD 92477EN
2.5
2.5
on
37