Service and Repair Manual
Specifications
Performance Specifications
Drive speed, maximum
Draw bar pull
Lift capacity, maximum
Boom function speeds, maximum
Boom up
Boom down
Boom extend
Boom retract
Fork rotate
2
Hydraulic Oil Specifications
18 mph
Hydraulic Fluid Specifications
29 km/h
Genie specifications require hydraulic oils which are
29,000 lbs
designed to give maximum protection to hydraulic
13,154 kg
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
10,000 lbs
exceed 140. They should provide excellent antiwear,
4545 kg
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
17 to 19 seconds
Cleanliness level,
23 to 25 seconds
minimum
14 to 16 seconds
Water content,
13 to 15 seconds
maximum
3 to 6 seconds
Recommended Hydraulic Fluid
Hydraulic oil type
Viscosity grade
Viscosity index
Optional Hydraulic Fluids
Mineral based
Biodegradable
Fire resistant
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie Product
Support before use.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond it's
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.
GTH-1056
April 2017
ISO 15/13
Chevron Rando HD Premium
Shell Tellus S2 V 32
Shell Tellus S2 V 46
Shell Tellus S4 VX 32 Shell
Shell Donax TG (Dexron III)
Chevron 5606A
Petro Canada Environ MV 46
UCON Hydrolube HP-5046
Optional fluids may not have the
same hydraulic lifespan and
may result in component
damage.
Part No. 1278145
250 ppm
32
200