Genie GTH-1056 Service And Repair Manual page 39

April 2017
14 Working at the pivot end of the boom, remove
the hose keepers from the hose roller
assembly.
Note: The hose keepers ensure that the hoses do
not jump off the hose rollers.
1 tube 3 extension chains
2 dual-chain tensioner
3 tube 2 extension chains
4 single-chain tensioner
5 boom tube number 0
6 boom tube number 1
7 boom tube number 2
8 boom tube number 3
15 Working at the pivot end of the boom, remove
the fasteners securing the cable bridge rear
mount bracket to the boom assembly. Remove
the bracket from the boom.
16 Working at the pivot end of the boom, tag,
disconnect and plug the hydraulic hoses at the
hard lines of the cable bridge. Cap the fittings.
Part No. 1278145
Boom Components
17 Working at the pivot end of the boom, remove
the fasteners securing the hose roller
assembly to boom tube number 1. Remove the
hose roller assembly from the boom.
18 Working at the fork end of the boom, remove
the fasteners securing the cable track mount
bracket to boom tube number 3.
1 cable bridge mount bracket
2 cable track mount bracket
3 cable bridge slider
19 Working at the fork end of the boom, remove
the fasteners securing the cable bridge slider
to the cable bridge. Remove the slider from the
boom.
Note: Pay attention to how the hoses are routed
before removing the slider from the boom.
Note: During reassembly, it may be helpful to use
tape to secure the bolts to the cable bridge when
installing the cable bridge slider.
20 Working at the fork end of the boom, securely
attach the loose end of the cable track to the
cable bridge using a cable tie or similar device.
GTH-1056
Service and Repair Manual
29