Operator's Compartment; Electrocution/Burn Hazard - Genie GTH-1056 Service And Repair Manual

Service and Repair Manual

Operator's Compartment

2-1
Operator's Compartment
How to Remove the Operator's
Compartment
The operator's compartment is used to activate
machine functions while sitting in the operator's
drivers seat.
Within the operator's compartment there is a
transmission column shifter, steering selector,
4-way controller, accelerator pedal, brake pedal
and a differential lock switch. All of these
components are replaceable.
For further information or assistance, consult the
Genie Product Support.
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting
this procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is strongly recommended.
1 Open the access door above the hydraulic
tank.
2 Disconnect the battery from the machine.

Electrocution/burn hazard.

Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
3 Locate the secondary function manifold under
the manifold inspection cover. Tag, disconnect
and plug the hydraulic hoses at ports BP and
BT of the secondary function manifold. Cap the
fittings. Refer to Secondary Function Manifold
Components.
36
4 Locate the brake manifold under the manifold
inspection cover. Tag, disconnect and plug the
hydraulic hose at the underside of the brake
manifold. Cap the fitting. Refer to Brake
Manifold Components.
5 Working under the dashboard, locate the
hydraulic hose at port L of the steering orbitral.
6 Working at the front axle, locate the hydraulic
hose connected to the front axle steer cylinder
at the operator's compartment side of the
machine. Tag, disconnect and plug the
hydraulic hose. Cap the fitting.
7 Tag, disconnect and plug the hydraulic hoses
at ports SUP, SUR and SUT of the secondary
function manifold. Cap the fitting.
8 Tag, disconnect and plug the hydraulic hose at
port SULS of the primary function manifold.
Cap the fitting.
9 Tag, disconnect and plug the hydraulic hose at
port JP of the secondary function manifold.
Cap the fitting.
10 Tag, disconnect and plug the hydraulic hoses
at ports J1, J2, J3 and J4 of the primary
function manifold. Cap the fittings.
GTH-1056
April 2017
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
Part No. 1278145