How To Remove The Cable Bridge Assembly - Genie GTH-1056 Service And Repair Manual

April 2017
How to R emove the Cable Bridg e Ass embl y
How to Remove the Cable Bridge
Assembly
Inside the four-section boom, a cable bridge is used
to route hydraulic lines through the boom assembly
to the fork level cylinder and auxiliary connections
(if equipped).
1 Remove the inspection cover at the pivot end
of the boom.
2 Working at the pivot end of the boom, remove
the fasteners securing the cable bridge rear
mount bracket to the boom assembly. Remove
the bracket from the boom.
1 cable bridge mount bracket
2 cable track mount bracket
3 cable bridge slider
3 Working at the pivot end of the boom, tag,
disconnect and plug the hydraulic hoses at the
hard lines of the cable bridge. Cap the fittings.
Part No. 1278145
Boom Components
4 Working at the pivot end of the boom, remove
the fasteners securing the hose roller
assembly to boom tube number 1. Remove the
hose roller assembly from the boom.
5 Working at the fork end of the boom, remove
the fasteners securing the cable track mount
bracket to boom tube number 3.
6 Working at the fork end of the boom, remove
the fasteners securing the cable bridge slider
to the cable bridge. Remove the slider from the
boom.
Note: Pay attention to how the hoses are routed
before removing the slider from the boom.
Note: During reassembly, it may be helpful to use
tape to secure the bolts to the cable bridge when
installing the cable bridge slider.
7 Working at the fork end of the boom, securely
attach the loose end of the cable track to the
cable bridge using a cable tie or similar device.
8 Working at the pivot end of the boom, carefully
remove the cable bridge from the boom.
GTH-1056
Service and Repair Manual
21