Prog_Event Function; Fast I/O - Siemens SINUMERIK 808D Function Manual

Note
All of the numbers that have been entered must be confirmed with the following hardkey.
23.5

Prog_Event function

With the Prog_Event function, two subroutine programs called "CYCPE1MA.SPF" and "CYCPE_MA.SPF" are triggered to be
executed at certain states such as the end of a program, NC reset, etc.. You must first create at least one of the
CYCPE1MA.SPF and CYCPE_MA.SPF files, and then save the file(s) under the cycle directory (N: \CMA).
Relevant parameters:
No. Name
11450 SEARCH_RUN_MODE
20106 PROG_EVENT_IGN_SINGLEBLOCK 1FH
20107 PROG_EVENT_IGN_INHIBIT
20108 PROG_EVENT_MASK
20109 PROG_EVENT_MASK_PROPERTIE
S
23.6

Fast I/O

Hardware description
The FAST I/O interface (X21) provides 3 digital inputs and 1 digital output:
Illustration
Relevant parameters
MD No. Name
10366 HW_ASSIGN_DIG_FASTIN[0]
10368 HW_ASSIGN_DIG_FASTOUT[0]
212
Value
7H
CH
Actual value
1H
Pin Signal Description
4 DI1 Fast input 1 with address DB2900.DBX0.0
5 DI2 Fast input 2 with address DB2900.DBX0.1
6 DI3 Fast input 3 with address DB2900.DBX0.2
7 DO1 Fast output 1 with address DB2900.DBX4.0
Descriptions
-
-
-
Triggering modes for N: \CMA\CYCPE1MA.SPF and
N: \CMA\CYCPEMA.SPF:
Bit 0: activating the program event during the NC
•
commissioning
Bit 1: activating the program event at the end of a
•
NC program
Bit 2: activating the program event using the
•
RESET key
Bit 3: activating the program event after powering
•
up the NC
-
Meaning
Hardware assignment for the fast inputs
Hardware assignment for the fast outputs
Variable
$A_IN[1]
$A_IN[2]
$A_IN[3]
$A_OUT[1]
Value
10101
10101
Function Manual
01/2017