Setting Data - Siemens SINUMERIK 808D Function Manual

Number
20107 PROG_EVENT_IGN_INHIBIT
20108 PROG_EVENT_MASK
20109 PROG_EVENT_MASK_PROPERTIES
20110 RESET_MODE_MASK
20112 START_MODE_MASK
20116 IGNORE_INHIBIT_ASUP
20117 IGNORE_SINGLEBLOCK_ASUP
20700 REFP_NC_START_LOCK
21000 CIRCLE_ERROR_CONST
20150 GCODE_RESET_VALUES
20152 GCODE_RESET_MODE
Auxiliary function settings of the channel
Number
Channel-specific
22000 AUXFU_ASSIGN_GROUP[n]
22010 AUXFU_ASSIGN_TYPE[n]
22020 AUXFU_ASSIGN_EXTENSION[n]
22030 AUXFU_ASSIGN_VALUE[n]
22550 TOOL_CHANGE_MODE
Timers and counters of the channel
Number
Channel-specific
27860 PROCESSTIMER_MODE
27880 PART_COUNTER
27882 PART_COUNTER_MCODE[n]
Display machine data
Number
283 ... 292
10.7.2

Setting data

Number Identifier
Channel-specific
42000 THREAD_START_ANGLE
42010 THREAD_RAMP_DISP
42100 DRY_RUN_FEED
Function Manual
01/2017
Identifier
Identifier
Identifier
Identifier
Prog events ignore the read-in disable
Eventdriven program calls
Prog event properties
Initial setting at RESET
Initial setting at special NC Start after power-up and at
RESET
Execute user ASUPs completely in spite of reading
disable
Process user ASUPs completely in spite of single-block
processing
NC-Start disable without reference point
Circle end point monitoring constant
Reset G groups
G code basic setting at RESET
Auxiliary function group [aux. func. no. in chan-
nel]: 0...63
Auxiliary function type [aux. func. no. in channel]: 0...63
Auxiliary function extension [aux. func. no. in channel]:
0...63
Auxiliary function value [aux. func. no. in channel]:
0...63
New tool offset for M function
Activation of the program runtime measurement
Activation of the workpiece counters
Workpiece counting via M command, n = 0 ... 2
Setting of the display for the graphic simulation
Name
Start angle for thread
Starting and deceleration distance of feed axis in thread
cutting G33
Dry run feedrate
Name
Name
Name
Name
101