Host Interfaces; Power - Printronix t8000 Administrator's Manual

Host Interfaces

1. Serial RS-232 at 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, or
2. USB 2.0
3. Ethernet 10/100
4. Wireless 802.11 a/b/g/n
5. Parallel (Centronics compatible) or IEEE 1284 bi-directional.
The RS-232 host interfaces shall have the following characteristics:
Word Length:
Handshaking:
Input Buffer:

Power

Power Source:
Grounding:
Energy Power
Saver Mode
Standby
25% Print Density
50% Print Density
T8 in Thermal Transfer Print Mode, +15 Intensity, 120VAC 60Hz input, 70 degrees F @ 40% RH
278
Table 21. Host Interface Characteristics
115200 baud.
Table 22. Power Source and Grounding
Table 23. Power Consumption
4 inch printers
203 dpi 300 dpi
14 ips 12 ips
4 Watts 4 Watts
34 Watts 34 Watts
194 Watts 153 Watts
321 Watts 237 Watts
Selectable 7-bit or 8-bit data format
XON/XOFF (in receive mode only) and
CTS/DTR
Selectable from 1k through 16 kbytes.
XOFF is transmitted and DTR goes low
when buffer is equal to or less than 25%
of full. XON is transmitted and DTR goes
high when buffer is 25% above empty.
Characters are transmitted with no parity
from the printer
115 or 230 VAC 50/60Hz switching power
supply.
Unit must be connected to a properly
grounded receptacle.
6 inch printers
203 dpi 300 dpi
12 ips 10 ips
4 Watts 4 Watts
37 Watts 37 Watts
219 Watts 186 Watts
346 Watts 294 Watts
8 inch printers
203 dpi 300 dpi
10 ips 8 ips
4 Watts 4 Watts
37 Watts 37 Watts
257 Watts 241 Watts
425 Watts 408 Watts