Printronix t8000 Administrator's Manual page 195

Network > Control > Job Control
Determines how the end-of-job packet is handled (when the
acknowledgement is sent back to the host system).
The NIC waits for the entire job to be received before it
Standard
indicates the job is done.
The NIC waits for the entire job to be printed before it
Enhanced
indicates the job is done.
The EOJ (End of Job) packet is acknowledged
immediately. Use this option if the job is timed out due
Fast Standard
to a delay in the acknowledgement of the EOJ packet
because of the amount of data being printed.
There is no synchronization between the NIC and the
Off
printer when printing a job.
Factory Default Standard
Network > Control > Offline Process
Determines whether the network will process data while OFFLINE.
When set to disable, the printer does not process
Disable
network data while OFFLINE.
When set to enable, the printer continues to process
Enable (but not print) the current network/parallel job while the
printer is OFFLINE until the printer's buffer is full.
Factory Default Disable
Network > Control > AutoSW Timeout
This is the timeout value used for the network to check the other port types
for data to print. When the printer has not received data from the host after a
certain period of time, it needs to time out in order to service the other ports.
Minimum 10 second
Maximum 60 seconds
Factory Default 10 seconds
195