Printronix t8000 Administrator's Manual page 267

Table 13. LCD Message Troubleshooting
Displayed Message
OPTION NOT INSTALLED
OPTION CARD ERR
---------------------
2 BLANK CARDS PRESENT
REMOVE ONE CARD AND
THEN POWER-UP TO THE
ONLINE STATE AND THEN
INSTALL THE 2ND CARD.
OVERALL GRADE FAIL
Solution/Explanation
If the printer is powered on with the cutter enabled in Media >
Handling > Media Handling, but the cutter itself is open (in
the down position, or the cutter upper enclosure is removed)
the printer cannot detect the cutter. When using the cutter,
the printer must be powered on with the cutter in the up
position and the cutter upper enclosure installed.
1. Check that the cutter option is installed, connected in
the up position, and the upper enclosure installed
before powering on the printer.
2. Install the cutter option or change to the correct option
in the Media > Handling > Media Handling menu.
3. If the error persists, contact your authorized customer
service representative.
Error message indicating that two blank option card are
installed. The printer cannot handle two blank cards
simultaneously so the following procedure will need to be
followed.
1. Turn off printer.
2. Remove one of the option cards.
3. Power-up the Printer to the ONLINE state.
4. Turn off printer.
5. Reinstall the removed option card.
Overall data validation failure: decodeability, percent decode,
defects, modulation, EC Min, Rmin, and/or symbol contrast.
1. Press Pause to clear the message.
2. Adjust the parameter that is causing the failure. Run a
Validator > Diagnostics > Scan Report to see which
parameter failed.
3. Lower the Validator > Grading > Overall Grade to a point
where the worst parameter grade will be above this
threshold.
267