Printronix t8000 Administrator's Manual page 306

Command
PRINTJOB
306
Table 28. Thermal PTX_SETUP Commands
Sub-Command
LENGTH
MEDIA_HANDLING
MIRROR
MODE
ODV
OVERSTRIKE
WIDTH
START
END
Parameter
Value Sets the page length in 1/1000"
units.
Value Sets the type of media handling:
0 - Continuous
1 - Tear-Off Strip
2 - Tear-Off
3 - Peel-Off
4 - Cut
Value Value of 0 turns mirroring off,
non-zero turns mirroring on.
X Sets the print mode to Thermal
Transfer.
D Sets the print mode to Direct
Thermal.
1
Enables the ODV unit so that ODV
begins verifying printed barcodes.
0 Requests the printer to back up one
form (as defined by the Form
Length) and then print out an
overstrike pattern.
This command should only be used
if the Validator > Control > Validator
Action is set to Retry Form.
Value Sets the page width in 1/1000"
units.
jobID
Start of job marker. Results in a
"start of job" message sent back to
host through the PPM port when a
j b t t
jobID End of job marker. Results in a "end
of job" message sent back to host
through the PPM port when the job
f
Description
i ti