Printronix t8000 Administrator's Manual page 73

Media > Handling > Pre-Peel Mode
Pre-Peel Mode adds a forward and reverse motion to each label prior to
printing. The added forward pre-peel motion temporarily breaks the die cut
label from the liner, and the reverse motion places the label back on the liner
prior to printing, peeling, or dispensing the label. Pre- Peel Mode is usually
enabled only when using die cut labels with an aggressive adhesive that
makes automatic label removal from the liner difficult.
Disable No motion.
Enable Enables the forward and reverse motion prior to print.
Factory Default Disable
Only applies when Media Handling is set to
IMPORTANT
Peel-Off and Peel-Off Mode is set to Standard.
Media > Handling > Pre-Peel Adjust
When Pre-Peel Mode is set to Enable, Pre-Peel Adjust represents the
selectable distance that the label advances during Pre-Peel Mode. The
Pre-Peel Adjust distance selected is automatically used when Pre-Peel Mode
is enabled. Increments in 0.01 inches.
Minimum 0.00 inches
Maximum 2.00 inches
Factory Default 1.00 inches
Media > Handling > Cal in Peel Mode
This option allows you to perform a calibration in Peel-Off Media Handling
mode. Calibration in Peel-Off mode does not stop and wait for you to remove
peeled labels. Therefore, be prepared to remove the labels as they are
automatically peeled.
Calibration from the panel when in peel mode is not
Disable
permitted and a warning message will display.
Auto Calibrate can be performed from the front panel in
Enable
peel mode.
Factory Default Disable
This menu is only visible when the peel option is
IMPORTANT
installed.
If this menu is set to Disable, then Power-Up
IMPORTANT
Action = "Auto Cal" is ignored.
73