Printronix t8000 Administrator's Manual page 31

2. Open the media cover and refer to the Label Peel-Off illustration on the Ribbon and Media Loading
instruction label on the inside of the cover.
Bottom Roller
Paper Path
1. Open the front door by pulling it upward, then forward.
2. Open the pivoting deck by rotating the deck lock lever clockwise until the deck swings upward.
3. Thread the media (label and liner) over the tear bar and around the bottom roller, then through the
opening at the bottom of the front door and into the printer.
IMPORTANT
If you do not complete the following step, it will be difficult to remove the liner
from the rewinder.
3. Turn the release lever on the rewinder counterclockwise and lock it in place. This forms a raised ridge
along the width of the rewinder.
4. Insert the leading edge of the media into the closest slot of the rewinder, and slide the media against
the back flange.
5. Hold the media in the slot and rotate the rewinder one full revolution counterclockwise until the media
is taut.
6. Remove labels from the liner so that behind the tear bar the liner is void of labels for about 1.5 inches
and below the tear bar for about 2 inches.
7. Close the front door.
8. Complete the media routing as shown in Figure 2.
9. Press down on both sides of the pivoting deck and rotate the deck lock lever fully counterclockwise.
10. Press the FEED key. The label advances to the peel-off position, and "Remove Label" displays on the
LCD.
11. Manually remove the peeled label from the printer.
12. Press the PAUSE key until the ONLINE screen displays.
13. Close the media cover.
Tear Bar
Pivoting
Deck
Deck Lock
Lever
31