Fitting The Wall Liners & Fuel Effect; Fitting The Rear Wall Liner (Vermiculite/Ceramic/Glass); Fitting The Glass Liners Spacer Support And Filler Piece; Fitting The Side Wall Liners - Valor 500FS Installer And Owner Manual

INSTALLER GUIDE
12. FITTING THE WALL LINERS
There are a range of wall liners available some may have a patterned or in the case
of the glass a mirrored side depending on the liner set purchased. Ensure the
decorated or glass mirrored side is fitted facing outwards.
12.1 Fitting the rear wall liner. (Vermiculite/Ceramic/Glass)
Locate the rear ceramic wall against the rear wall of
the convector box. Please note that when fitting this
liner into the convector box it should be angled first on
the flat to fit inside the inner convector box then gently
raised to locate into the rear wall section.
Care must be taken to avoid damage to the liners
when fitting.
12.2 Fitting the Glass liners spacer support.
This must be carried out before fitting the Glass side
wall liners. Inside the accessory box you will find two
metal spacer brackets and 4 screws. Locate the glass
liner spacer to the LHS and RHS of the convection box
using the 4 screws supplied.
Note: When fitting the glass wall liner kit there is also
a third metal filler piece that should be fitted in place
after assembling back into place the
top tray. This filler piece is placed to the
rear of the top tray to fill in the gap
between the top tray and the rear glass
liner

12.3 Fitting the side wall liners.

(Vermiculite/Ceramic/Glass)
Offer the side wall liners into the convection box. The
top of the ceramic side walls should be located first.
With the top in place gently slide the side wall until it
is flat against the side of the convection box. There is
a soft bend metal tab at the base of the side liner this
can be bent up at 90 degrees to secure the walls in
place.
© Page 29
GDC Group Ltd. SEPT 2016