Table of Contents
Advertisement
INSTALLER GUIDE
12. FITTING THE WALL LINERS
There are a range of wall liners available some may have a patterned or in the case of
the glass a mirrored side depending on the liner set purchased. Ensure the decorated or
glass mirrored side is fitted facing outwards.
12.1A Fitting the Single piece rear wall liner. (Ceramic
& Glass only)
Locate the rear ceramic wall against the rear wall of the
convector box. Please note that when fitting this liner into
the convector box it should be angled first on the flat to fit
inside the inner convector box then gently raised to
locate into the rear wall section.
12.1B Fitting the Two or Three piece rear wall liner.
(Vermiculite)
The 600 & 800 rear wall liners come as a two piece and
the 1000 is in three pieces. Locate each rear ceramic
wall against the rear wall of the convector box. Please
note that when fitting this liner into the convector box it
should be angled first on the flat to fit inside the inner
convector box then gently raised to locate into the rear
wall section.Fit each piece side to side leaving no gaps.
PLEASE NOTE: Care must be taken to avoid damage to the liners when fitting.
12.2 Fitting the Glass liners spacer support.
This must be carried out before fitting the Glass side wall
liners. Inside the accessory box you will find two metal
spacer brackets and 4 screws. Locate the glass liner
spacer to the LHS and RHS of the convection box using
the 4 screws supplied.
Note: When fitting the glass wall liner kit there is also a
third metal filler piece that should be fitted in place after
assembling back into place the top tray.
This filler piece is placed to the rear of
the top tray to fill in the gap between the
top tray and the rear glass liner
12.3 Fitting the side wall liners.
(Vermiculite/Ceramic/Glass)
Offer the side wall liners into the convection box. The
top of the ceramic side walls should be located first.
With the top in place gently slide the side wall until it is
flat against the side of the convection box. There is a
soft bend metal tab at the base of the side liner this can
be bent up at 90 degrees to secure the walls in place.
©
Page 29
GDC Group Ltd. NOV 2017
Advertisement
Table of Contents
