Preparing Appliance For Installation - Valor 500FS Installer And Owner Manual

INSTALLER GUIDE

9. PREPARING APPLIANCE FOR INSTALLATION

1. Remove the visual baffle, by unscrewing by hand
the two M5 knurled screws in an anti clockwise
direction. Keep these two screws save as they will be
needed later. Carefully slide out the visual baffle and
place carefully to one side.
2. Remove the glass door, by unscrewing by hand the
two M5 knurled screws in an anti clockwise direction
located just under the base of the door frame. Keep
these two screws save as they will be needed later.
Carefully lift out at the base then up and away from
the convection box. Place carefully to one side.
3. Remove the Log set box and carefully place to one side.
4. Lift up and out the Top tray and carefully place to
one side. There are no screws holding this tray
inplace.
5. Unscrew the base tray, then remove by lifting up
and out. Place to one side carefully.
© Page 21
GDC Group Ltd. SEPT 2016