Burner - Valor 500FS Installer And Owner Manual

- Light coatings of soot will usually be burnt off during the normal operation of the fire.
Should any soot accumulation become excessive, the effected overlay log or ceramic
fuel effect base should be removed from the fire for cleaning.
- Cleaning should be carried out in a well ventilated area or in the open air by gently
brushing with the pieces held away from your face so that you avoid inhaling the dust.
- We do not recommend the use of a normal domestic vacuum cleaner which may
blow dust back into the air.
- We suggest that you remove the ceramic fuel effect pieces in the reverse order to
that shown in the ceramic fuel effect installer and owner guide.
- Once cleaned replace the log fuel effect as in ceramic fuel effect installer and owner
guide.

Burner.

To gain access to the burner the window assembly, ceramic components and top tray
must be removed as in the previous sections.
Remove any deposits of soot or other foreign matter from the surface of the burner
with a dry soft brush. Be careful not to brush any particles into the open slots.
Remove any particles from the slots with a vacuum cleaner fitted with a soft brush
attachment. Do not poke wire, etc. into the slots in the burner.
© Page 55
GDC Group Ltd. SEPT 2016