Pack Contents - Valor 500FS Installer And Owner Manual

The items required for this appliance are packed in sections.
The Ceramic/Vermiculite/Glass liner options are all fragile so care necessary
when handling. They are packed inside the top fitment as you open the carton.
Section 1 - Fire unit contains:
1 Burner and convection box unit.
1 Log fuel effect set
1 Literature packs
1 Frameless kit
Section 2 - Accessory box contains:
1 Wall liners set
1 Self adhesive foam seal
2 Self adhesive foam seal
7 Wood screws
7 Wood Wall plugs
2 Cable clamps
2 Fire retaining cables
4 Eyebolts
2 Floor sealing tape
1 'T' connector and pressure test point.
1 Nut and olive for 8mm inlet pipe.
1 Smoke match tube
1 Ember wool
1 Slider handle
2 M4 x 8 machine screws
1 Alkaline 'AA' Battery
1 8 button remote control handset. (RC models only)
2 Alkaline 'AAA' Batteries.
1 Battery box
4 Alkaline 'AA' Batteries.
1 Tray filler
2 Side wall glass spacers
4 No.8 x 3/8" Tapping Screws
Section 3 - Trim pack contains:
1 Trim.
4 Square magnets
Carefully remove all the contents. Take special care in handling the ceramic pieces.
Check that all the listed parts are present and in good condition.
©
GDC Group Ltd. SEPT 2016
INSTALLER GUIDE

6. PACK CONTENTS

(ONLY If ordered instead of a Trim)
(ONLY with Frameless kit extra foam seal)
(500 Models approx 0.5 gram)
(FS only)
(FS only - to secure the Slider handle)
(FS models only)
(RC models only)
(RC models only)
(RC models only)
(Only on models with Glass liners selected)
(Only on models with Glass liners selected)
(Used to fit the side wall spacers)
(Used to secure Trim onto engine)
Page 19