Wall Mounting; Gas Supply Connection; Fit The Ceramic Fuel Effect And Window - Valor Black Beauty Slimline Installation And Owner's Manual

7.2 Wall mounting.

The fixing hole positions in relation to the flue spigot opening are shown in figure 12.
Mark these positions on the wall. The positions can alternatively be marked by
placing the fire in position and marking the wall
through the holes in the back panel. Drill and plug
the holes using no.10 wall plugs. Place the fire in
position and secure with four no.10 x 2in.
woodscrews.

7.3 Gas supply connection.

8mm rigid tubing must be used to connect the gas
supply to the appliance. An olive and nut are
provided for connection to the inlet "T" connector
on the appliance. The connector can be rotated to
allow connection from either side or the rear. The
connector includes a valve for isolating the gas
supply.
The closure plate has a cut-out for rear connection.
Seal the gap between the cut-out and the supply
pipe.
Pressure check the installation pipework for gas
soundness. In the United Kingdom check in
accordance with the current edition of BS6891. In
the Republic of Ireland refer to the current edition
of IS 813 "Domestic gas installations".

7.4 Fit the ceramic fuel effect and window.

1. Place the ceramic fuel effect in position. Make sure that it rests on the ledges at
the sides of the firebox and that its back face is touching the horizontal rib at the back
of the firebox (See figure 13).
2. Replace the window unit. Secure the window unit to the firebox the two screws
removed previously.
©
GDC Group Ltd. JAN 2017
INSTALLER GUIDE
Page 21
Figure 13. Ceramic fuel
effect location