Adjusting Flame Height (Rc); Adjusting To Pilot Only (Rc); Turing Off (Rc); Lighting The Fire (Fs) - Valor 500FS Installer And Owner Manual

Continuing signals confirms the ignition is in progress. There will be a slight delay
-
and several sparks should be seen between the electrode and pilot tip.
On sensing a flame is not present the burner unit will shut off. If there are no sparks
-
check the following:
13.3.2 Adjusting flame height.
When the burner is operating press
the 'DOWN' button to decrease the
flame height, then press the 'UP'
button to increase the flame height.
Repeat these steps with the two
burners ignited.
13.3.3 Adjusting to pilot only
setting.
When the burner is operating press
and hold the 'DOWN' button until
the burner flame extinguishes. To
turn the main burner on again
simply press and hold the 'UP' button.
13.3.4 Turning off.
To turn the fire off press the 'ON/OFF' button.
Slider Control models - 600FS & 800FS
13.3.5 Lighting the fire.
Push the slider handle to the LEFT as far as possible till the ignition position is
-
reached, several sparks will occur between the electrode and pilot tip. Hold in this
position till the pilot flame has heated the thermocouple sufficiently to hold.
Approx. 5 - 15 seconds.
©
GDC Group Ltd. SEPT 2016
INSTALLER GUIDE
Page 31