Flame Supervision And Spillage Monitoring System - Valor 500FS Installer And Owner Manual

INSTALLER GUIDE
that has an opening of its own. The smoke
match should be placed horizontally into
this opening so that it touches the right
hand side of the opening 100mm deep. It
should pass the upper part of the opening
by 25mm.
The installation is satisfactory if the smoke
is drawn into the appliance.
If the smoke is not drawn into the appliance
leave the appliance alight at the maximum
setting for a further ten minutes and then
repeat the test. If the smoke is still not
Smoke match tube position
drawn into the appliance inspect the sealing
to the fireplace surround. If the sealing is
satisfactory but the appliance is installed with the flue restrictor (See section 9, point
8) adjust the restrictor height, reseal the appliance and retest. If smoke is still not
drawn into the appliance disconnect the appliance and seek expert advice.
5. If the above test is satisfactory open all internal connecting doors, hatches, etc. in
the room. Keep all doors and windows that open to the outside of the building closed.
Recheck for spillage as above. If an extractor fan is installed in the same room as the
appliance or a connecting room, check that spillage does not occur with the fan
operating and all doors and other openings between the fan and the appliance open.
If the smoke is drawn into the appliance, continue with the installation. If the test is
not satisfactory disconnect the appliance and advise the customer of the cause
of failure.

15.3 Flame supervision and spillage monitoring system.

This pilot unit includes a system that will automatically shut off the gas supply if the
pilot flame goes out or if there is insufficient oxygen due to spillage or poor ventilation.
This monitoring system must not be adjusted, bypassed or put out of
operation.
This monitoring system or any of its parts must only be exchanged using Valor
authorised parts.
© Page 35
GDC Group Ltd. SEPT 2016